ADLINK aTCA-N700 - Manual (Page 56)

aTCA-N700 SW Users Guide
５０
RDBGC0.xe0 : 24,999,987 +0
R64.xe0 : 97,654 +0
R127.xe0 : 6,152,568 +0
R255.xe0 : 18,652,091 +0
R511.xe0 : 97,674 +0
RPKT.xe0 : 24,999,987 +0
RUCA.xe0 : 24,999,987 +0
RPRM.xe0 : 24,999,987 +0
RPOK.xe0 : 24,999,987 +0
RBYT.xe0 : 3,999,973,180 +0
T64.xe0 : 1 +0
T127.xe0 : 4 +0
T255.xe0 : 5 +0
TPOK.xe0 : 10 +0
TPKT.xe0 : 10 +0
TUCA.xe0 : 10 +0
TBYT.xe0 : 1,299 +0
PERQ_PKT(10).xe0 : 10 +0
PERQ_BYTE(10).xe0 : 1,299 +0
8.3.8. Port mirroring configuration
‘dmirror’ sets mirroring option for a selected portto a target port.
Usage (DMIRror): Parameters: [Mode=]
[DestPort=]
[DestModule=] [DestTrunk=]
[MirrorTagProtocolID=] [MirrorVlanID=
DestTrunk overrides DestModule/DestPort.
TPID and VLAN are set only if DestPort is a local port.
Port mirroring configuration examples are shown below.
** Mirror port xe0 ingress packet to xe3.
BCM.0> dmirror xe0 m=ingress dp=xe3
** Display mirrong status.
BCM.0> dmirror show
** Remove xe0 mirroring.
BCM.0> dmirror xe0 m=off
8.3.9. rcload
‘rcload’ executes switch command scripts.
Usage (RCLoad): Parameters: [parameters]
Load commands from a file until the file is complete or an error
occurs. If optional parameters are listed after they are
pushed as local variables for the file processing. For example:
rcload fred a bc will result in the variables:
$1 = a
$2 = bc
during processing of the file.
For platforms where FTP is used, the user name, password and host
may be specified as: "user%password@host:" as a prefix to the
file name