Hold switch -> o, Turning on and off ^ o, Turning off the power – Aiwa XP-R970 User Manual
Page 10: Standby mode o, Adjusting the sound 0, Inserting a disc g, 1 slide open to open the disc compartment, 3 ciose the compartment, To remove the disc o, Before playback
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
BEFORE PLAYBACK
English
10
HOLD switch
-> O
Release the HOLD switch before playback; @
When not using the unit, set the HOLD switch to the
HOLD position. Accidentally pressed button will not
function. ®
If buttons are pressed when the HOLD switch is set to
HOLD position, “HOLd” flashes in the display.
Turning on and off ^ O
Turning the power on
Press^ll PLAY/PAUSE. Power is turned on and
playback starts.
Turning off the power
If no new operation is made after 30 seconds from the
end of last operation, the power is turned off
automatically. (Auto power off function)
• You can turn off the power before it is automatically
turned off by pressing the ■STOP/OFF/CHARGE.
Standby mode O
When an operation finishes, the unit goes into standby
mode until the auto power off function automatically turns
Off the power.
To enter standby mode, press ►!! PLAY/PAUSE to start
playback, then press ■ STOP/OFF/CHARGE.
Adjusting the sound 0
Volume
Turn the VOL control to adjust the volume.
DSL
Set the DSL switch for more powerful sound and deeper
bass.
1:
Deep bass is emphasized.
2:
Deep bass is more emphasized.
OFF: Normal sound
Inserting a disc G
1 Slide OPEN to open the disc compartment.
2 Piace a disc in the center with the iabel side facing
up.
3 Ciose the compartment.
To remove the disc O
Pick up the disc holding its edge, while pressing the pivot
gently.