Cisco 15600 - Manual (Page 75)

17-75
Cisco ONS 15600 Procedure Guide, R8.0
Chapter 17 DLPs E100 to E199
DLP- E196 Change a Section DCC Termination
DLP-E196 Change a Section DCC Termination
Step 1 Click the Provisioning > Comm Channels > SDCC tabs.
Step 2 Click the SDCC that you want to change.
Step 3 Click Edit.
Step 4 In the SDCC Termination Editor dialog box, complete the following as necessary:
• Disable OSPF on SDCC Link—If checked, OSPF is disabled on the link. OSPF should be disabled
only when the slot and port connect to third-party equipment that does not support OSPF.
• Far End is Foreign—Check this box to specify that the SDCC termination is a non-ONS node.
• Far End IP—If you checked the Far End is Foreign check box, type the IP address of the far-end
node or leave the 0.0.0.0 default. An IP address of 0.0.0.0 means that any address can be used by the
far end.
Step 5 Click OK.
Step 6 Return to your originating procedure (NTP).
DLP-E197 Change a Line DCC Termination
Step 1 Click the Provisioning > Comm Channels > LDCC tabs.
Step 2 Click the LDCC that you want to change.
Step 3 Click Edit.
Step 4 In the LDCC Termination Editor dialog box, complete the following as necessary:
• Disable OSPF on LDCC Link—If checked, OSPF is disabled on the link. OSPF should be disabled
only when the slot and port connect to third-party equipment that does not support OSPF.
Purpose This task modifies an SDCC termination. You can enable or disable Open
Shortest Path First (OSPF) and enable or disable the foreign node setting.
Tools/Equipment None
Prerequisite Procedures DLP-E26 Log into CTC, page 16-33
Required/As Needed As needed
Onsite/Remote Remote
Security Level Provisioning or higher
Purpose This task modifies a SONET LDCC termination. You can enable or disable
OSPF and enable or disable the foreign node setting.
Tools/Equipment None
Prerequisite Procedures DLP-E26 Log into CTC, page 16-33
Required/As Needed As needed
Onsite/Remote Remote
Security Level Provisioning or higher