Cisco 15600 - Manual (Page 29)

17-29
Cisco ONS 15600 Procedure Guide, R8.0
Chapter 17 DLPs E100 to E199
DLP- E133 Change User and Security Settings for Multiple Nodes
Note User settings that you changed during this task will not appear until that user logs off and logs
back in again.
Step 5 Return to your originating procedure (NTP).
DLP-E133 Change User and Security Settings for Multiple Nodes
Note You must add the same user name and password to each node the user will access.
Step 1 From the View menu, choose Go To Network View. Verify that all the nodes where you want to add
users are accessible in network view.
Step 2 Click the Provisioning > Security > Users tabs. Click the user’s name whose settings you want to
change.
Step 3 Click Change. The Change User window appears.
Step 4 In the Change User dialog box, you can:
• Change a user’s password.
• Modify the user’s security level.
• Lock out the user.
See the “DLP-E36 Create a New User on Multiple Nodes” task on page 16-48 for field descriptions.
Step 5 In the Select applicable nodes list dialog box, uncheck any nodes where you do not want to change the
user’s settings (all network nodes are selected by default).
Step 6 Click OK. The User Change Results confirmation dialog box appears.
Step 7 Click OK. Confirm that the changes appear; if not, repeat the task.
Step 8 Return to your originating procedure (NTP).
Purpose This task changes an existing user’s settings for multiple nodes.
Tools/Equipment None
Prerequisite Procedures DLP-E26 Log into CTC, page 16-33
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser