Cisco 15600 User Manual
Page 13
17-13
Cisco ONS 15600 Procedure Guide, R8.0
Chapter 17 DLPs E100 to E199
DLP- E113 Provision a Half Circuit Source and Destination on a Path Protection
DLP-E113 Provision a Half Circuit Source and Destination on a Path Protection
Step 1
From the Node drop-down list, choose the node that will contain the half circuit.
Step 2
From the Slot drop-down list, choose the slot containing the card where the circuit will originate.
Step 3
From the Port drop-down list, choose the port where the circuit will originate.
Step 4
If applicable, choose the source STS.
Step 5
If you want to create a path protection with two sources, click Use Secondary Source and repeat Steps
through
. If not, skip this step and continue with
Step 6
Click Next.
Step 7
From the Node drop-down list, choose the node chosen in
Step 8
From the Slot drop-down list, choose the destination slot.
Step 9
From the Port drop-down list, choose the destination port.
Step 10
If applicable, choose the destination STS.
Step 11
If you want to create a path protection with two destinations, click Use Secondary Destination and
repeat Steps
through
Step 12
Return to your originating procedure (NTP).
Purpose
This task provisions a half circuit source and destination for a path
protection. This task is used to create path protection selectors on the node.
Depending on the specific network configuration, the path protection
selector can be created on the source side (two sources, one destination);
the destination side (one source, two destinations); or both (two sources,
two destinations). Selectors are required on both the source and destination
sides when two STS path protection paths (rings) are interconnected at a
single node.
Tools/Equipment
None
Prerequisite Procedures
NTP-E83 Create a Half Circuit on a Path Protection Node, page 6-20
The Source page of the Circuit Creation wizard must be open.
Required/As Needed
As needed
Onsite/Remote
Onsite or remote
Security Level
Provisioning or higher