Cisco 15600 User Manual
Page 3
17-3
Cisco ONS 15600 Procedure Guide, R8.0
Chapter 17 DLPs E100 to E199
DLP- E102 Apply a Lockout in a 1+1 Group
Step 6
Click Yes in the confirmation dialog box.
The lock on has been applied and traffic cannot be switched from that port. See the
Lock On or Lockout in a 1+1 Protection Group” task on page 17-53
Step 7
Return to your originating procedure (NTP).
DLP-E102 Apply a Lockout in a 1+1 Group
Note
A Lock Out can be applied to a protect port only.
Step 1
In node view, click the Maintenance > Protection tabs.
Step 2
In the Protection Groups field, click the protection group that contains the card you want to lock out.
Step 3
In the Selected Group area, select the card you want to lock out.
Step 4
In the Inhibit Switching field, click Lock Out.
Step 5
Click Yes on the confirmation dialog box.
The lock out has been applied and traffic is switched to the opposite card. To clear the lockout, see the
“DLP-E168 Clear a Lock On or Lockout in a 1+1 Protection Group” task on page 17-53
Step 6
Return to your originating procedure (NTP).
DLP-E103 Initiate a Manual Switch on a Path Protection Circuit
Step 1
In node view, click the Circuits > Circuits tabs.
Purpose
This task locks traffic out of a protect port in a 1+1 protection group,
which prevents traffic from switching to that port.
Tools/Equipment
None
Prerequisite Procedures
DLP-E26 Log into CTC, page 16-33
Required/As Needed
As needed
Onsite/Remote
Onsite or remote
Security Level
Provisioning or higher
Purpose
This task switches traffic to the path protectionusing a Manual switch.
A Manual switch will switch traffic if the path has an error rate less than
the signal degrade.
Tools/Equipment
None
Prerequisite Procedures
DLP-E26 Log into CTC, page 16-33
Required/As Needed
As needed
Onsite/Remote
Onsite or remote
Security Level
Provisioning or higher