Dlp-e116 remap the k3 byte – Cisco 15600 User Manual
Page 17
17-17
Cisco ONS 15600 Procedure Guide, R8.0
Chapter 17 DLPs E100 to E199
DLP- E116 Remap the K3 Byte
Step 6
Click Apply.
Step 7
As needed, repeat this task for each port.
Step 8
Return to your originating procedure (NTP).
DLP-E116 Remap the K3 Byte
Caution
If you remap the K3 byte, remap to the same extended byte (Z2, E2, or F1) on either side of the span.
Step 1
In node view, double-click the card that connects to the third-party equipment.
Step 2
Click the Provisioning > Line tabs.
Step 3
Click BLSR Ext Byte and choose the alternate byte: Z2, E2, or F1.
Step 4
Click Apply.
Step 5
at the node and card on the other end of the BLSR span.
Note
The extension byte set in Step
should match at both ends of the span.
Step 6
Return to your originating procedure (NTP).
DLP-E119 Set Auto-Refresh Interval for Displayed PM Counts
Purpose
This task provisions the K3 byte. Do not remap the K3 byte unless
specifically required to run an ONS 15600 BLSR through third-party
equipment. This task is unnecessary for most users.
Tools/Equipment
None
Prerequisite Procedures
DLP-E26 Log into CTC, page 16-33
Required/As Needed
As needed
Onsite/Remote
Onsite
Security Level
Provisioning or higher
Purpose
This task changes the window auto-refresh intervals for updating the PM
counts.
Tools/Equipment
None
Prerequisite Procedures
DLP-E26 Log into CTC, page 16-33
.
Required/As Needed
As needed
Onsite/Remote
Onsite or remote
Security Level
Retrieve or higher