Cisco 15600 User Manual
Page 61
17-61
Cisco ONS 15600 Procedure Guide, R8.0
Chapter 17 DLPs E100 to E199
DLP- E180 Provision Path Trace on Circuit Source and Destination Ports
DLP-E180 Provision Path Trace on Circuit Source and Destination Ports
Note
This task assumes you are setting up path trace on a bidirectional circuit and setting up transmit strings
at the circuit source and destination.
Step 1
From the View menu, choose Go to Network View.
Step 2
Click the Circuits tab.
Step 3
For the STS circuit you want to monitor, verify that the source and destination ports are on a card that
can transmit and receive the path trace string.
provides a list of cards that support path trace.
Step 4
Choose the STS circuit you want to trace, then click Edit.
Step 5
In the Edit Circuit window, click the Show Detailed Map check box at the bottom of the window. A
detailed map of the source and destination ports appears.
Step 6
Provision the circuit source transmit string:
a.
On the detailed circuit map, right-click the circuit source port (the square on the left or right of the
source node icon) and choose Edit J1 Path Trace (port) from the shortcut menu.
shows
an example.
Purpose
This task creates a path trace on STS circuit source ports and destination.
Tools/Equipment
ONS 15600 cards capable of transmitting and receiving path trace must be
installed at the circuit source and destination ports. See
for a list
of cards.
Prerequisite Procedures
DLP-E26 Log into CTC, page 16-33
Required/As Needed
As needed
Onsite/Remote
Onsite or remote
Security Level
Provisioning or higher
Table 17-1
ONS 15600 Cards for Path Trace
J1 Function
Cards
Transmit and Receive
ASAP (Gigabit Ethernet ports)
Receive Only
ASAP (Optical ports)
OC48/STM16 LR/LH 16 Port 1550
OC48/STM16 SR/SH 16 Port 1310
OC192/STM64 LR/LH 4 Port 1550
OC192/STM64 SR/SH 4 Port 1310