Motor, To connect machine to electric service line – SINGER 201 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Motor
The SINGER* electric motor, located at
back of machine, is regularly furnished
for operation on a direct current of
110-120 volts or on alternating current
of 110-120 volts, 25 to 75 cycles. Special
motors can be furnished for direct or
alternating current for any voltage be-
tvsreen 50 and 250, and for 32 volts direct
current.
To Connect Machine to Electric Service Line
Before connecting the machine to elec
tric service line, be sure that the voltage
and the number of cycles stamped on the
motor nameplate are within the range
marked on the electric meter installed
by the electric power company.
Push terminal plug into the three-pin
terminal block (see Fig. 2, page 4) at
the right of machine and connect plug at
other end of cord to an electric outlet.
CAUTION
When you have finished your sewing, always dis
connect plug from electric outlet.
5