To make a felled seam with foot hemmer – SINGER 201 User Manual
Page 44
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
of material trimmed, allowing for
about 3^ inch of seam. Insert the two
edges of material, right sides to
gether, in the hemmer in same man
ner as a single hem as shown in
Fig. 41. If the material is bulky,
place edge of upper piece of material
about inch left of edge of under
piece.
2. The free edge of hemmed seam may
be stitched flat to garment, if de
sired. To do this, open the work out
flat, wrong side up, then insert the
hem in scroll of hemmer, holding
edge of hem in position while it is
being stitched. If seam is stitched
flat to garment, one row of stitching
is visible on the right side.
Fig, 41. Making a
Hemmed Seam
(^Second Operation^
To Make a Felled Seam
with Foot Hemmer
1. Place right sides of material together,
having edge of upper piece about 3^
inch to the left of edge of under
piece. Stitch the two pieces together,
using hemmer as a presser foot.
Guide both pieces by the projecting
toe of hemmer, as shown in Fig. 43.
43