SINGER 201 User Manual
Page 40
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
against the edge of the slot in the ring
and push it around in the direction op
posite to the hook rotation until the
circular cutout B is opposite the spring
D, as shown in Fig. 37. The ring E and
bobbin case may then be lifted out.
When replacing the parts,
first place the bobbin case [
into position with the finger
A, Fig. 37 in the opening in
the position plate under the
throat plate as shown in
Fig. 37. Turn the bobbin
case back and forth slightly
to make sure that it is proper
ly seated, then place the hook
ring E in position with the
cutout B opposite the spring
D. Press the ring into place
and turn it in the direction
of hook rotation until the
spring locks it in position.
Then replace the bobbin.
THROAT PLATE
Fig.
37.
View from Left End, Showing
Keflacement of Bobbin Case
39