To start hem at very edge – SINGER 201 User Manual
Page 42
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
The foot hemmer may
be used for hemming
edge of material, mak
ing hemmed and felled
seams and for hemming
and sewing on lace in
one operation.
Raise needle to its high
est point, remove pres
ser foot and attach foot
hemmer to presser bar
in place of presser foot.
Pull up bobbin thread as instructed on
page 16.
To Start Hem at Very Edge
1. Fold edge of material twice, about
^ inch each time, for a distance of
about two inches. Crease folds.
Fig. 38
Foot Hemmer
2. Lay about three inches of needle and
bobbin threads back under hemmer.
Place creased edge of material under
hemmer with end of hem directly
under needle. Lower hemmer and
tack end of hem with two machine
stitches.
Fig, 39. Starting Hem at Very End of Material
41