To replace the bobbin and thread the bobbin case – SINGER 201 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Fig. 12. Adjustment of Bobhm Winder
Loosen adjusting screw 0, Fig. 12.
With forefinger, push back upper end of
slotted plate
P
as far as it will go,
as shown in Fig. 12, and at the same
time, press bobbin winder pulley against
hub of hand wheel. Tighten adjusting
screw 0. If thread does not wind
evenly on bobbin, loosen screw which
holds tension bracket 2, Fig. 11 in
position.
Move bracket to the left if bobbin winds
high on right; move bracket to the right
if bobbin winds high on left. When
bracket is properly centered, thread will
wind evenly across bobbin.
Bobbins can be wound while machine is
sewing, by following instructions on
page 12, omitting item 3-
TO REPLACE THE BOBBIN AND
THREAD THE BOBBIN CASE
Hold bobbin between thumb and fore
finger of left hand; thread drawing from
right to left, as shown in Fig. 13.
Place bobbin in bobbin case. Draw
thread into slot 1, Fig. 14 in bobbin
case, as shown in Fig. 14.
Draw thread toward front between bob
bin case and tension spring until it
passes notch 2, Fig. 15 in bobbin case,
as shown in Fig. 15. Close slide and at
14