To attach the binder, To insert binding in binder, To insert garment in binder – SINGER 201 User Manual
Page 48
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
found particularly advantageous for
making children’s wear, lingerie, sum
mer dresses, and other dainty articles
which call for narrower bindings.
As two different widths of binding of
contrasting colors can be fed through
binder at same time, attractive binding
and piping effects can be produced in
one operation.
To Attach the Binder
Raise needle to its highest position.
Then attach binder to presser bar in
place of presser foot.
See that needle enters center of needle
hole.
To Insert Binding In Binder
Cut all binding to a long point to the
left, as shown in 48.
Folded bias binding
must be inserted in the
slot or slots of corre
sponding sizes. See
Fig. 51.
Unfolded or raw edge
bias binding must be
inserted in the open
end of the scroll. See
Fig.
4 9
.
After inserting pointed
end of binding in bind
er, push it through until full width of
binding is under needle.
Guide binding by means of two upright
pins, as shown in Figs. 49 to 53.
To Insert Garment in Binder
Place edge to be bound as far to right as
it will go in center slot of scroll C2, as
shown in Fig.
4 9
, and draw it back
under binder foot.
Fig. 48
47