SINGER 201 User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
The numerals on the stitch indicator
plate V denote the approximate num~
her of stitches per inch.
To change length of stitch, loosen
thumb screw X and move it to bottom
of slot. Move stitch regulating lever W
until its upper side is in line with the
number of the desired length of stitch.
Move thumb screw X until stitch regu
lating plate (inside) touches lever W.
Tighten thumb screw X.
The machine will then make the indi
cated number of stitches to the inch in
either a forward direction (lever W at
lowest position) or a reverse direction
(lever W at highest position).
Fig. 20
Stop machine with thread take-up lever
5, Fig. 19 at its highest position. Raise
presser foot, draw the fabric back and
to the left, and sever the threads on
thread cutter T, Fig. 19* Place ends of
threads under presser foot, as shown in
Figo 18,
18