TeeJet LH665 VRT - Manual (Page 60)

D ATA CARDS & DATA MANAGEMENT LH 665 VRT O PERATORS MANUAL
11.4 LH A GRO
USING DATA CARDS
THE FIRST TIME A DATA CARD IS USED
Insert the data card in the LH 665 before the unit is switched on. The LH 665
automatically determines the data card type. If the data card being used is
different than the one supplied with the LH 665 then the procedure is as follows:
Step Key Procedure
1 Switch the LH 665 off.
2 Insert the data card and switch the LH 665 on again.
3 This screen is displayed:
CANCEL ACCEPT
CARD TYPE: UNKNOWN
Select card type
SRAM CARD
ATA FLASH CARD
4 Select the card type being used using the ARROW
UP/DOWN keys.
5
ACCEPT
Press the ACCEPT key and the following screen may be
displayed (depending on data card type):
CANCEL ACCEPT
CARD TYPE: SRAM
Select SRAM Card size
256 KB
512 KB
1 MB
2 MB
4 MB
Other SRAM Sizes not supported