TeeJet LH665 VRT - Manual (Page 25)

LH 665 VRT O PERATORS MANUAL A PPLICATION CONTROL , OPERATION
LH A GRO 3.9
THE CONNECTION BETWEEN FIELD AND LOAD KEYS
The following example shows how, amongst others, the total weight shown is
affected when the LOAD key is pressed or not:
Step Key Procedure
1 Press on of the four FUNCTION keys to highlight a section
on the screen.
2 Whilst the section is highlighted press the lower ARROW
keys until the WEIGHT key is shown, then press this key.
3 Press the MENU key until the following menu selection keys
are shown at the bottom of the display (screen section C):
FIELD LOAD SHOW MAP OPTIONS
4 LOAD The total units for the load can be seen when the LOAD key
is pressed. If the total units for another load is to be seen
then change the load (see page 3.7).
5 FIELD The total units for the field can be seen when the FIELD key
is pressed. If the total units for another load is to be seen
then change the load (see page 3.7).
It is possible to switch between showing information for a
field or a load.