TeeJet LH665 VRT - Manual (Page 39)

LH 665 VRT O PERATORS MANUAL A PPLICATION CONTROL , ENCODE & CALIBRATION
LH A GRO 4.5
ADVANCED SETTINGS
Target Rate Outside Field:
The default setting is Zero. This setting is used to determine what rate should be
applied if the implement is outside the field boundary (from the target file).
When the default setting (Zero) is used and the implement is not in the field
boundary, the application rate will be set to 0.
If TGT default is selected then the default rate (from the file) will be used if the
implement is not in the field boundary.
If Use last is selected then the last rate applied before the implement left the field
boundary will be used.
Controller Time Delay:
The time, in seconds, the implement takes to adjust the present rate to a newer
rate.
Actual Rate Units:
Ignore this setting.
Log Actual Rate:
The default setting is YES. If no log of what has actually happened in the field is
required set this to NO.