TeeJet LH665 VRT - Manual (Page 41)

LH 665 VRT O PERATORS MANUAL A PPLICATION CONTROL , ENCODE & CALIBRATION
LH A GRO 4.7
MARKER SETUP
Step Key Procedure
1
MARKS
Press the MARKS key and the following is displayed:
MARKER SETUP
MARK NAME TYPE
MARK 1 Stones SPOT
MARK 2 Weeds CONTINUOUS
MARK 3 Draining CONTINUOUS
MARK 4 Other SPOT
EXIT
EDIT
NAVN
EDIT
TYPE
2 Highlight the marker to be encoded with the ARROW
UP/DOWN keys.
3
EDIT
NAME
SAVE
NAME
After pressing this key the name of the marker can be
changed using the ARROW UP/DOWN keys. Move the
cursor from letter to letter using the RIGHT/LEFT ARROW
keys.
Press the SAVE NAME key when the marker name is
encoded.
The marker name does not affect how the marker is
registered in the LH 665. All markers are registered as
marker 1-4 in the LH 665 and mapping software. We
recommend therefore, noting which marker is associated to
which marker name.
4
EDIT
TYPE
ACCEPT
It is possible to change the marker type by pressing the EDIT
TYPE key. CONTINUOUS and SPOT markers can be
selected by using the ARROW UP/DOWN keys.
Press the ACCEPT key once the marker type have been
encoded.
CONTINUOUS marking is started and stopped by pressing
the marker key during operation.
SPOT marking is started by pressing the marker key during
operation and stops automatically after a few seconds.
5
EXIT
When all the marker names and marker types have been
encoded press the EXIT key.