TeeJet LH665 VRT - Manual (Page 22)

A PPLICATION CONTROL , OPERATION LH 665 VRT O PERATORS MANUAL
3.6 LH A GRO
START NEW LOAD
The procedure for starting new loads is almost the same as described above for
starting new fields.
Step Key Procedure
1 Press the MENU key until the following menu keys are
displayed at the bottom of the screen (screen section C).
FIELD LOAD MARKS
2
LOAD
Press the LOAD key twice to display the following screen:
ACCEPT CANCEL
F1: L1: DG
ACTIVE LOAD
L1:
PRESS TO EDIT NAME
ACTIVE CONFIGURATION
PRODUCT CONTROLLER CHANNEL
PRODUCT 1 LH 5000 N/A
3 The loads can be named and the procedure for this is the
same as for naming fields.
4
ACCEPT
Press the ACCEPT key.
Note! We recommend creating new loads as the need arises and not like
fields before harvest.
USING LOAD NUMBERS
Typically the fields will be worked as one load. It is not necessary to split the fields
into loads unless it is required. The following example shows a field split into two
loads.
Example of a field split into two loads:
Load 1 Load 2 This example shows how it is possible to
split a field into two different loads.
The marked area (load 2) shows an area
of the field that was, e.g. wet.