SilentKnight SKE-450 Voice Evacuation Control Panel - Manual (Page 45)

151267 6-1
Section 6
SKE-ZN6 Six Zone Splitter Installation
This section contains information on how to install the SKE-ZN6 Zone Splitter into the SKE-
450 cabinet, and how to connect input and output devices to the zone splitter.
A zone splitter is a device that can split the audio output from the main amp into separate
audio output channels. The SKE-ZN6 is capable of splitting the audio to six separate zones.
The SKE-ZN6 can be used in installations where the audio needs to be split to different floors
or zones to accommodate a safe and efficient evacuation process.
Important: See Section 6.4.4 and 6.4.5 for output control of speaker circuits by zone or general
alarm.
Note: Each speaker circuit is capable of 20 watts maximum power not to exceed 50 watts for the system.
6.1 SKE-ZN6 Board and Components
Figure 6-1 SKE-ZN6 Board Components
Terminal
Strip 1
Manual Zone
Switches
Zone 1
Zone 2
Zone 3
Zone 4
Trouble LEDs
Active LEDs
All Call
Switch
Terminal Strip 2
Terminal
Strip 3
SKE-450 Direct
Connect
Zone 5
Zone 6