SilentKnight SKE-450 Voice Evacuation Control Panel - Manual (Page 31)

Programming
151267 4-3
4.2 Recording Custom Message
The SKE-450 comes with three recorded messages (see Table 4-2). Message 1 & 2 can be
changed through the 7780 software; Message 3 can be recorded from the microphone or by
using the 7780 software. Message 1 & 2 are 32 seconds long, and Message 3 is 49 seconds
long.
When in the record mode, the Speaker Trouble and Mic Trouble LEDs will function as
follows:
While in record mode, the Message Test Buttons are used as follows:
S1: Replay the recorded message. Message will continue to repeat until the S1 button is
pressed again.
S2: Used to erase message 3. To erase the user message, press S2 until the Speaker Trou-
ble LED turns on. When the Speaker Trouble LED turns off again, the message will be
fully erased.
Table 4-2: Preprogrammed Messages
Message No. Voice Gender Message
Message 1 Female ATTENTION PLEASE. There has been a report of an emergency.
Proceed calmly to the nearest exit and leave the building immediately.
Do not use the elevators. Use stairwells where necessary. All
handicapped occupants shall use the building’s evacuation plan.
Message 2 Male We have a fire alarm in our building. Please stay in your apartment and
keep your apartment doors closed; Keep your windows shut and leave
all fire doors closed. Do not use the elevators, and stand by for further
instructions.
Message 3 Female ATTENTION PLEASE. The signal tone you have just heard indicates a
report of an event in the building. Please await further instructions
while the report is being verified. If further action is necessary, you will
be instructed to follow floor response plans.
Table 4-3
LED LED Appearance Meaning
Speaker Trouble Solid ON Erasing user message.
FLASHING Recording user message.
OFF Normal mode (not recording)
Mic Trouble ON Flash is programmed with user message.
OFF Flash is erased.
FLASHING Flash error, need to erase and re-record.