Reznor R6GP Unit Installation Manual - Manual (Page 48)

709288B (Replaces 709288A)
*
* AHRI commercial furnace certification listing applies only to 3 phase units
having an input rate 225,000 Btu/hr or greater
Specifications & illustrations subject to change without notice or incurring obligations.
O’ Fallon, MO | Printed in U.S.A. (09/12)
INSTALLATION / PERFORMANCE CHECK LIST
GAS SYSTEM
Gas Type: (circle one) Natural Gas Propane
Gas pipe connections leak-tested? YES NO
Gas Line Pressure: ____________________________ (in - W.C.)
Is there adequate fresh air supply
for combustion & ventilation?
YES NO
Installation Altitude: _________________________________ (FT.)
Deration Percentage: _________________________________ (%)
Furnace Input: ____________________________________(Btuh)
Supply Air Temperature: _____________________________ (° F)
Return Air Temperature: _____________________________ (° F)
Temperature Rise: _________________________________ (° F)
During Furnace Operation:
Low fire manifold pressure: ______________________ (in - W.C.)
High fire manifold pressure: ______________________ (in - W.C.)
REFRIGERATION SYSTEM
Was unit given 24 hr warm up period
for crankcase heaters?
YES NO
Did reversing valve energize? YES NO
Stage-1 Liquid Pressure (high side) ________________________
Stage-1 Suction Pressure (low side) ________________________
Stage-2 Liquid Pressure (high side) ________________________
Stage-2 Suction Pressure (low side) ________________________
INSTALLATION ADDRESS:
CITY ________________________ STATE ________________
UNIT MODEL # ________________________________________
UNIT SERIAL # _______________________________________
Unit Installed within the Minimum
clearances specified on page 10?
YES NO
INSTALLER NAME:
CITY _______________________ STATE ________________
Has the owner’s information been
reviewed with the customer?
YES NO
Has the Literature Package been left
with the unit?
YES NO
ELECTRICAL SYSTEM
Electrical connections tight? YES NO
Line voltage polarity correct? YES NO
Rated Voltage: ___________________________________ VOLTS
L1-L2 Volts: _____________________________________ VOLTS
L1-L3 Volts: _____________________________________ VOLTS
L2-L3 Volts: _____________________________________ VOLTS
Avg.Volts: _______________________________________ VOLTS
Max. Deviation of Voltage
From Avg Volts ___________________________________ VOLTS
% Volt Imbalance: ________________________________ VOLTS
Blower Motor HP: ________ Sheave Setting ___________# Turns
Has the thermostat been calibrated? YES NO
Is the thermostat level? YES NO
Is the heat anticipator setting correct? YES NO
VENTING SYSTEM
Is the vent hood installed? YES NO
Is vent hood free from restrictions YES NO
Filter(s) secured in place? YES NO
Filter(s) clean? YES NO