Installation, Notice – Proheat X45–School Bus User Manual
Page 22
SECTION 3. INSTALLATION
3-1
INSTALLATION
The installation details described in this manual focuses on truck applications
and does not cover all of the possible installations. As seen in the figures
below, the PROHEAT X45 is installed on a variety of equipment including
trucks, school buses, coaches, drill rigs, mine dump trucks and excavators.
In these cases the manual should be used as a guideline only.
There are seven major steps that must be completed to successfully install
the PROHEAT heater.
3.1
LOCATING THE HEATER......................................................... page 3-2
3.2
MOUNTING THE HEATER ....................................................... page 3-4
3.3
EXHAUST PIPE CONNECTION ................................................. page 3-6
3.4
PLUMBING THE SYSTEM ....................................................... page 3-7
3.5
WIRING & ELECTRICAL CONNECTIONS ................................. page 3-10
3.6
FUEL SYSTEM .................................................................... page 3-22
3.7
FIRST TIME STARTUP .......................................................... page 3-26
Prior to the installation of your PROHEAT, consult your engine owner’s manual
or engine manufacturer for any restrictions or changes that may apply to
plumbing into the engine coolant system.
3.0
NOTICE
If additional installation information is
required please contact your PROHEAT
Dealer regarding your specific
application.
For more technical information,
please contact PROHEAT Product
Support at www.proheat.com
®
®
Figure 3-1
Other Applications.