LAARS NeoTherm NTV (Sizes 150–850 MBTU/h) - Install and Operating Manual - Manual (Page 34)

Page 30 LAARS Heating Systems
Section 7 -
THE USER INTERFACE
7.1 About the User Interface
The User Interface of the NeoTherm used on this unit has
two main parts:
• the ‘Display’ area and
• the ‘Buttons’
The User Interface displays operating and setup information
sent from the NeoTherms electronic burner controller and
allows the user to set all parameters of the electronic burner
controller.
Table 10 - Button Functions on User Interface
Fig. 26 - The User Interface (UI)
Display area This area displays several different kinds of information, including current
operating information, setup parameters, and messages from the SOLA
controller.
Up/ Down Arrow buttons Use these to go to the choice you want to select in the display area, then
press the round OK button.
Left/ Right Arrow buttons Use these to go to the choice you want to select in the display area, then
press the round OK button.
Back button Use this to go back to the previous display.
Info/ Install button Press this button at any time to go to the sub-menus that allow you to set up
and monitor the controller.
Home button Press this button at any time to go back to the Home display. (See the section
on “Home Display.”)
Round OK button Use the round OK button to confirm a value or action.
Note – Sometimes the system will present the Keyboard display screen, which
also includes a separate “OK” area. This is not the same as the round OK
button – the two have different functions.)
Install Operating Manual
Doc# 1218G-NH.pdf Doc# 1252-NH.pdf
(this document)
The Neotherm ‘User Interface’ was updated for the 2013
model year to the User Interface shown in this manual.
For older NeoTherms, you will need to download the
1218G-NH.pdf from the ‘Discontinued Documents’ on
Laars.com.
Display area
currently showing
the Home Display
Up/Down
Arrow
buttons
Left/Right
Arrow
buttons
Back button
Info/Install
button
Home button
Round OK button