LAARS NeoTherm NTV (Sizes 150–850 MBTU/h) - Install and Operating Manual - Manual (Page 10)

Page 6 LAARS Heating Systems
Figure 8 - Contents of Shipping Package
1.4 Warranty
LAARS Heating Systems’ NeoTherm appliances are covered
by a limited warranty. The owner should complete the
warranty registration at www.Laars.com.
All warranty claims must also be made at www.Laars.com. or
to an authorized LAARS Heating Systems representative.
Claims must include the serial number and model (this
information can be found on the rating plate), installation
date, and name of the installer. Shipping costs are not included
in the warranty coverage.
Some accessory items may be shipped in separate packages.
Verify receipt of all packages listed on the packing slip.
Inspect everything for damage immediately upon delivery,
and advise the carrier of any shortages or damage. Any such
claims should be filed with the carrier. The carrier, not the
shipper, is responsible for shortages and damage to the
shipment whether visible or concealed.
1.5 Unpacking
The NeoTherm unit is shipped in a single crate with the
following standard components packed with the appliance.
(See Figure 8.)
A. Exhaust vent terminal (US only)
B. Air intake terminal
C. Temperature/pressure gauge kit
D. Circulator pump/wire harness (units with pump)
E. CPVC exhaust pipe section (80-850) (US only)
F. Outdoor/system sensor kit
G. Flow switch kit (399-850)
H. Alternate size vent/terminal screens
J. Exhaust vent adapter CPVC/ST ST (750-850)
K. 4x6 PVC adapter with 4x7 PVC pipe section
(750-850) (not to be used on exhaust in Canada)
1. Remove all packing and tie-down materials.
2. Check the contents of the carton against the items
shown.
1.6 Dimensions
All NeoTherm model dimensions are shown in Figure 9.