KGUARD Security TC801 - Manual (Page 74)

ENGLISH
Chapter 5: KGUARD Web Client
74
DVR User’s Manual
Setting Up Email
Use the Email Setup menu to configure the sending and receiving email servers to send and receive email alarm
notifications.
1
On the Main Menu, click SETUP.
2
On the left panel, click Network > Email. The Email screen appears.
3
On Status, select Enable.
4
Modify the necessary settings.
Menu item Description
SSL SSL (Secure Sockets Layer) protocol is used to secure your email account. Set SSL to
Enable if the email server needs the SSL verification. Check with your email service
provider for the applicable setting.
SMTP Port Enter the SMTP port of the email server that you want to use to send emails.
Note:
By default, the SMTP port is 25 for email without SSL verification. For Gmail server
or for email that needs SSL verification, the SMTP port is 465, by default. Check with
your email service provider for the correct setting.
SMTP
Server
Enter the SMTP server of the email server that you want to use to send emails.
Send Email Enter the email address from where you want to send the email.
Send
Password
Enter the sender’s email password.
Recv Email Enter the email address where you want to send the email alarm notification.
5
After all settings are complete, click Apply at the bottom of the screen.
« TIP »
• To revert to default settings, click Default at the bottom of the screen.
• To cancel any modifications or close the screen, click
.