KGUARD Security TC801 - Manual (Page 69)

ENGLISH
Chapter 5: KGUARD Web Client
DVR User’s Manual
69
7
To disable motion detection on an area, click a marked block and then drag the mouse to highlight the scope that
you want to unmark (area turns white). Or, click Clear to unmark all areas and then select a new area to mark for
motion detection.
8
To save the settings, click Apply at the bottom of the screen.
When motion detection is enabled on a channel, the motion detection icon M appears on the channel screen shown
on the monitor connected to the DVR.
« TIP »
• To revert to default settings, click Default at the bottom of the screen.
• To cancel any modifications or close the screen, click
.
Alarm Setup
1
On the Main Menu, click SETUP.
2
On the left panel, click Alarm.
3
On the Alarm submenu, select Other.
4
Modify the necessary settings.
Menu item Description
Video Loss Check to trigger the alarm when the camera signal is not detected.
HDD Space Check to trigger the alarm when there is not enough hard disk space.
HDD Loss Check to trigger the alarm when the hard disk drive is not detected.
Buzzer Set the buzzer duration when motion is detected (OFF/10s/20s/40s/60s).
Post Rec Select the post recording time after the alarm ends.
(5s/10s/15s/20s/30s/1Min/2Min/5Min).
5
After all settings are complete, click Apply at the bottom of the screen.
« TIP »
• To revert to default settings, click Default at the bottom of the screen.
• To cancel any modifications or close the screen, click
.