KERN & SOHN AET 200-4NM - Manual (Page 69)

AET_/PET_/ILT_NM-BA-e-1410 69
PROCEDURE:
1. Press < Target Value > key,
2. Insert the target value expressed in [%],
3. If tolerance applies, set its value,
4. Accept by pressing < > key,
5. Press High Threshold key and insert its value in [%],
6. Accept by pressing < > key
18.3. Interpreting the function by use of a bargraph
The dosing and checkweighing functions are aided by graphic indication, in a
form of a bargraph. Below see an example of simultaneous operation of the
two functions.
a) checkweighing thresholds < > are set as Low Threshold = 90%,
High Threshold = 110%
b)
Target value = 105% ; tolerance = 5% < >
c)
Reference mass = 19.986 g < >
18.4. Additional settings of Percent Setup mode
The additional settings enable adjusting the working mode to user’s needs and
requirements. Functions related to checkweighing: result control, tare mode,
automatic footer printout, printout mode / value release, printouts.
Means of using the above functions are given in point 9.7 “Additional
parameters on weighing process”.