Juniper Systems Mesa User Guide - Manual (Page 37)

Suspend, Reset, Power Off, and Restore the Mesa
Use the power button and the power menu to suspend,
reset, power off or restore the Mesa. To access the Power Button
menu, press and hold the power button.
Suspending and Resuming the Mesa
We recommend suspending your Mesa if you plan to turn it
off for less than two weeks. While it is suspended, you should
attach it to a wall charger when it is not in use.
Suspending the Mesa is different from powering it off. When
the device is suspended it goes into a very low power mode.
Some battery power is used during suspend.
1. Press and release the power button . The backlight shuts
off and the green LED turns on. It can take several seconds
to fully suspend, especially when the cell modem is on. The
green LED turns off when suspend is complete.
2. To resume the device from suspend mode, press and
release the power button again. When it is resumed, the
Mesa resumes where it was before it was suspended.
Ch 3 Programs and Settings
37