Juniper Systems Mesa User Guide User Manual

Page 10

background image

10

Mesa Rugged Notepad Owner’s Manual

3. Use the installation card to push air bubbles out (it may

take a few days for air bubbles to get worked out).

4. Never use sharp objects to adjust or remove the screen

protector.

Charge the Battery Pack(s)

Install and charge the Li-Ion battery pack(s). The Mesa is

designed to use 1 or 2 battery packs. Using two battery packs

extends the operating time of the unit. Geo 3G models should

always use two battery packs.
Complete the following steps:
1. The battery compartments are located on the back of the

Mesa. Loosen the quarter turn latches holding the battery

compartment door(s) in place using a coin or similar object

(loosen them enough to slightly lift the door, making it

easier to grab). Remove the door(s).

Note: If you are using one battery, for the best ergonomics we

recommend you use battery compartment #1 on the bottom

designated for battery 1 as shown in the following graphic.