Juniper Systems Mesa User Guide - Manual (Page 93)

General Safety
CAUTION: This device has been evaluated for use in close
proximity to the body. Use only accessories approved by
Juniper Systems. The use of third party accessories may
not comply with FCC and international RF exposure
requirements. To comply with FCC and other national RF
exposure requirements do not co-locate this device with other
transmitters.
This device operates in compliance with the FCC radio
frequency exposure limits for an uncontrolled environment.
Users must follow instructions provided in the user
documentation to satisfy compliance with FCC radio frequency
exposure requirements.
There cannot be any alteration to the authorized antenna
system. The antenna shipped with the cell modem is the only
one authorized for use.
This cell modem is compliant with FCC regulations when
operated within the temperature range of -30°C to +50°C. Do
not operate the cell modem outside of this temperature range.
European Union (CE Marking)
Products bearing the CE marking comply with the
2004/108/EC (EMC Directive), 1999/5/EC (R&TTE
Directive), 2006/95/EC (Low Voltage Directive) issued by the
Commission of the European Community.
CE compliance of this device is valid only if powered with/by a
CE-marked wall charger provided by the manufacturer. Cables
connecting to the USB host port must use a ferrite core/bead
on the cable. The ferrite core must be placed on the cable near
the end that connects to the Mesa. Compliance with these
directives implies conformity to the following standards:
„
EN 55022 (CISPR 22) Electromagnetic Interference
„
EN 55024 (IEC 61000-4-2, 3, 4, 5, 6, 8, 11) Electromagnetic
Immunity
!
Appendix B Product Warnings and Regulatory Information
93