Cabletron Systems DMS-100 - Manual (Page 82)

82 Chapter 3: EIU datafill
297-8991-910 Standard 03.01 August 1999
NODENAME = AP
If the entry in field NODENAME is AP, enter the data in the following
refinements:
• SMNINDEX
• SNADDR
• TCPCONN
• FTPCLCON
• FTPSVCON
• UNIXADDR
NODENAME AP, APU, CM ,
EIU, ELIU,
FP,MS Node name
Enter the node name:
• AP (application processor)
• APU (application processor UNIX)
• CM (computing module)
• EIU (Ethernet interface unit)
• FP (file processor)
• MS (message switch)
Note: You can enter AP and FP to
support the Supernode Unix (SNIX)
versions of the nodes. You can enter IP
addresses for both the software
operating system and the SNIX sides of
the nodes. You must enter the nodes in
table APINV. The IP address for an AP
or FP can be the software operating
side only or the software operating side
and SNIX side. You can enter one or
two IP addresses for an AP or FP node.
The application on the node determines
the number addresses to enter. A node
AP requires two IP addresses for the
node.
NODE refer to subfields Node
This field contains subfields for the
entries in field NODENAME.
Table 14 Field descriptions for table IPHOST for EIU datafill (continued)
Field Subfield or
refinement Entry Explana tion and action
(Sheet 2 of 2)