Cabletron Systems DMS-100 - Manual (Page 137)

Appendix C: Using FTP 137
DMS-100 Family EIU User Guide TELECOM12
Get an ASCII file from the DMS WS> ascii
WS> get file_name
where
file_name is the name of the file on the DMS that you want
to get. If the file name is in lowercase, use single quotation
marks around the name (including forward slashes).
The above command sequence
• sets the transfer type to ASCII
• gets the file from the current directory on the DMS
Because the workstation has no concept of record length,
the logical record length does not have to be set.
Send an ASCII file to the DMS WS> ascii
WS> site LRECL 132
WS> put file_name NEW_FILE_NAME
where
file_name is the name of the file on the host node.
NEW_FILE_NAME is the target file name on the DMS.
If file_name is in uppercase, new_file_name is optional
WS>put FILE_NAME.
The above command sequence
• sets the transfer type to ASCII
• sets the logical record length to 132 bytes
• puts the file in the current directory of the DMS
Send a LOAD68K file to the DMS WS> binary
WS> put file_name.load68k
where
file_name is the name of the file on the host node.
FILE_NAME$LD is the name of the target file on the DMS.
The above command sequence
• sets the transfer type to binary
• puts the file in the current directory of the DMS
Table 34 FTP operations reference: workstation to DMS
Action Command sequence
(Sheet 2 of 3)