Cabletron Systems DMS-100 - Manual (Page 39)

Chapter 1: Introduction to the EIU 39
DMS-100 Family EIU User Guide TELECOM12
Software for peripheral processors is controlled through package lists that
define the entities for a specific load. The EIU may have several loads
depending upon the applications resident on it.
As of CSP02, the EIU-related software is packaged in LANCOMM. Software
is available with TL_ALL LCF. EIU-related software is provided as part of
order code TEL00001.
EIU provisioning requirements
The provisioning rules for the total numbers of EIUs depend on the following
requirements:
• the applications running on the EIUs
• the total application capacity required for all EIUs on the switch
• the level of redundancy required by these applications
The provisioning requirements are subject to the maximum limit of eight EIUs
per switch.
The following sections describe the provisioning limits for the new
components.
DMS-bus inter-MS provisioning
Each message switch in an IML requires an NT9X17DA port card and an
NT9X20BB DS512 fiber paddle board.
Card position is not restricted. However, the cards associated with a link must
use the same slots in each MS. For example, if the cards in one MS are
provisioned in slot 21 (that is, the NT9X17DA is in 21F and the NT9X20BB
NTXF19AA TCP/IP This package is the protocol
software from the transport
layer down to the link layer.
NTXF19AA uses NTXF05AA.
NTXS11AA FTP This package is the standard
FTP client and server
software. NTXS11AA uses
NTXF19AA.
NTX70AA Telnet/RMAP This package is the standard
telnet server for remote MAP
(RMAP) access.
Table 1 DMS-Core feature packages
Package Title Description
(Sheet 2 of 2)