Interlogix NX-590NE - Manual (Page 8)

6 NX-590NE Internet Interface Installation Manual
Figure 1: Mounting the board
Wiring
Caution: Do not apply power to any component until the installation is complete.
Damage to components may occur if power is incorrectly applied.
CE and FCC Part B compliance
As of January 1, 1996, all new European Union member installations must be CE
compliant.
In addition, we recommend that you use the following wiring methods:
• Use 2-conductor, shielded security and alarm cable for the power cable.
• Connect the power cable shield to the earth terminal on the NX panel PCB
(see Figure 1 above).
Note: The other end of the power cable shield should be cut off and not
connected.
• Earth ground the NX panel. Connect the earth ground wire to the earth
terminal on the NX panel PCB and connect the other end at the cable’s
entrance to the panel or cable clamp. In addition, connect the nearest earth
ground to the panel or to the cable clamp as shown in Figure 2 on page 7.