Interlogix NX-590NE - Manual (Page 35)

NX-590NE Internet Interface Installation Manual 33
4. Set Location 4, Segments 1 to 16, to enable needed segments in used
partitions for e-mail or set to disable reporting.
5. Program Locations 13 to 16 with a valid name for the From field in the e-mail
message.
6. Program Locations 29 to 32 with a valid name for the To field in the e-mail
message for e-mail 1.
7. Program Locations 33 to 36 with a valid name for the To field in the e-mail
message for e-mail 2.
8. If using DNS, program Locations 37 to 40 with a valid name for the e-mail
server.
9. If not using DNS, program Locations 37 to 40 with the e-mail server IP
address.
10. Program Location 57 with the e-mail port (the default is 025).
Send events to receiver 1 only
To set up the NX-590NE to send events to receiver 1 only, do the following:
1. Set Location 1, Segments 1 to 16, to enable needed segments in used
partitions.
2. Set Location 2, Segments 1 to 16, to disable reporting to receiver 2.
3. Set Location 3, Segments 1 to 16, to disable reporting to e-mail 1.
4. Set Location 4, Segments 1 to 16, to disable reporting to e-mail 2.
5. Program Location 46 with the IP address for receiver 1.
6. Program Location 55 with the receiver alarm port number.
Send events to receiver 2 only
To set up the NX-590NE to send events to receiver 2 only, do the following:
1. Set Location 1, Segments 1 to 16, to disable reporting to receiver 1.
2. Set Location 2, Segments 1 to 16, to enable reporting to receiver 2.
3. Set Location 3, Segments 1 to 16, to disable reporting to e-mail 1.
4. Set Location 4, Segments 1 to 16, to disable reporting to e-mail 2.
5. Program Location 47 with the IP address for receiver 2.
6. Program Location 55 with the receiver alarm port number.