Interlogix NX-590NE - Manual (Page 34)

32 NX-590NE Internet Interface Installation Manual
Programming tasks
This section describes some common programming tasks.
Set up an IP address for the NX-590NE
You must set up a static IP address or use DHCP to get a dynamic IP address.
Failure to do so will result in the NX-590NE not functioning at all.
To assign a static IP to the NX-590NE, do the following:
1. Set Location 0, Segment 2, Option 3 to 0.
2. Set Location 45 to the assigned IP address (for example, 3.18.147.166).
3. Set Location 52 to the assigned gateway address (for example, 3.18.144.1).
4. Set Location 54 to the subnet mask (for example, 255.255.255.0).
5. You can now program IP addresses in the following locations:
• Location 46 - IP address for primary receiver
• Location 47 - IP address for secondary receiver
• Location 51 - IP address for mail server
• Location 53 - IP address for download computer
• Location 87 - automation (premise server) IP address
The IP address, gateway address, and subnet mask are parameters your system
administrator should be able to provide for the location where the NX-590NE will
be installed.
Set up a dynamic IP to the NX-590NE
To assign a dynamic IP to the NX-590NE using DHCP, set Location 0, Segment
2, Option 3 to 1. Locations 45, 52, and 54 are not used in this scenario.
Your system administrator should be able to tell you if the network supports
dynamic IP addressing for your installation.
Send events as e-mail messages only
To set up the NX-590NE to send events as e-mail messages only, do the
following:
1. Set Location 1, Segments 1 to 16, to disable reporting to receiver 1.
2. Set Location 2, Segments 1 to 16, to disable reporting to receiver 2.
3. Set Location 3, Segments 1 to 16, to enable needed segments in used
partitions for e-mail, or set to disable reporting.