Interlogix NX-590NE - Manual (Page 12)

10 NX-590NE Internet Interface Installation Manual
Programming
You can use an LED keypad or LCD keypad to program the module.
Using an LED keypad
To program the module with an LED keypad, do the following:
1. Enter *, 8. All of the function key LEDs will begin to flash.
2. Enter the Go To Program code (default is 9713). If the code is valid, the
Service LED will flash, and the function LEDs will illuminate steadily,
indicating you should enter the device to program.
3. Enter 7, 9, #, the address of the NX-590NE. The Armed LED will illuminate
until you enter a programming location.
4. Enter the programming location followed by the # key. The Armed LED will
begin to flash. If this is a valid location, the Armed LED will extinguish, the
Ready LED will illuminate, and the binary data for the first segment of this
location will appear on the Zone LED.
5. To change the data, enter the data followed by the * key. The location will
automatically increment to the next segment. The data for that segment will
display. Repeat the procedure until the system reaches the last segment.
6. To exit this location without changing the data, press the # key.
7. To review the data, press the * key but do not enter data. Each time you
press *, the next segment displays. After you program the last segment for a
location, press * to exit that location. The system will turn the Ready LED off
and the Armed LED on. As before, you are now ready to enter another
programming location.
Note: If you attempt to program an invalid entry for a particular segment, the
keypad sounder will emit a triple-beep and remain in that segment until there
is a valid entry.
8. To enter another location, do one of the following:
• Enter the location number followed by the # key.
• Press Police for the next location.
• Press Fire for the previous location.
• Press Auxiliary for the same location.
9. Press Exit to exit this module. Press Exit again, to completely exit program
mode.