Interlogix NX-590NE - Manual (Page 21)

NX-590NE Internet Interface Installation Manual 19
• Location 44 - Download computer name (characters 49 to 64)
Locations 45 to 53 - IP addresses
Locations 45 to 53 have four segments of numerical data. If you turned on static
IPs instead of dynamic DNS (Location 0, Segment 2, Option 3), you will need to
program Locations 45, 52, and 54 with the appropriate IP addresses. Otherwise,
the NX-590NE will use the addresses assigned by the DHCP Server.
The default is 0 0 0 0 for each location.
Note: If the DNS option is enabled (Location 0, Segment 2), Locations 46, 47,
51, and 53 are only used as a backup (not required).
• Location 45 - IP address for this module
• Location 46 - IP address for receiver 1
• Location 47 - IP address for receiver 2
• Location 48 - Reserved
• Location 49 - IP address for DNS 1
• Location 50 - IP address for DNS 2
• Location 51 - IP address for mail server
• Location 52 - IP address for gateway
• Location 53 - IP address for download computer
Location 54 - Subnet mask
Location 54 has four segments of numerical data. This location contains the
subnet mask (default 255.255.255.0). Contact your network administrator before
programming this location. This location must be configured so that all IP
addresses up to and including the local gateway are allowed. When using cable
modem/DSL, this will generally be the same as the computer. To obtain your IP
address, gateway, and subnet mask, do one of the following:
• For Windows 9X and Windows ME, at the DOS prompt, type
winipcfg .
• For Windows 2000 and XP, at the COMMAND prompt, type
ipconfig .
Note: Location 54 is not needed when using DHCP.
Location 55 - Receiver alarm port
Location 55 has four segments of numerical data. This location contains the IP
alarm port used by the TCP/IP receiver (default 9 9 9 9). Do not change this data
except as directed by your central station provider.