Interlogix NX-590NE - Manual (Page 7)

NX-590NE Internet Interface Installation Manual 5
Product overview
The NX-590NE is a dual microprocessor-controlled Internet/Intranet (TCP/IP)
interface used to connect the control panel to the OH Network Receiver. This
interface allows any or all events from the panel to be reported over the network.
The NX-590NE has a fixed address of 79 .
Installation
To install the interface module, you will need to mount and wire the board, and
enroll the module in the panel.
Mounting
We recommend that you mount the NX-590NE with UCSIMM PCB in the
mounting position located closest to the NX panel PCB as shown in Figure 1 on
page 6.. If another board is already mounted in the location closest to the NX
panel PCB, mount the NX-590NE in the next available location.
To mount the board, do the following:
1. Place the first black plastic PCB guide in the top insertion point, grooved edge
downward. The half-moon protrusion will be in the large hole. It does not
require force.
2. Insert one of the provided screws into the smaller hole (from the inside of the
enclosure) to secure it in place. Position a screwdriver through the notch that
runs the length of the guide, to tighten the screw.
3. Position the second PCB guide opposite the first (grooved edge up) and place
it in the lower insertion point, using the same procedure. Once you mount the
guide, screw it in securely.
4. Slide the board into both guides.