Interlogix NX-590NE - Manual (Page 23)

NX-590NE Internet Interface Installation Manual 21
time/number of attempts). The default is 30 seconds divided by 2 attempts for 15
seconds per attempt.
Segment 1 - Number of retries for failed network attempts. The default is 2.
Segment 2 - Time in seconds for overall retries of failed network attempts (0 to 255 seconds).
We recommend a minimum of 30 seconds. The default is 30.
Segment 3 - Polling time in seconds (time to wait between successful transmissions). The
default is 10 (if set below 10, it will default to 10).
Segments 4 to 6 - Reserved
Locations 64 to 71 - Partition account number
Locations 64 to 71 have eight segments of numerical data. Use these locations
to program the account number for the partitions being used. The default is 0 0 0
0 0 0 0 0. If these locations are programmed with anything other than 0 0 0 0 0 0
0 0, it will override Location 60 (SIA/CID).
• Location 64 - Partition 1 account number
• Location 65 - Partition 2 account number
• Location 66 - Partition 3 account number
• Location 67 - Partition 4 account number
• Location 68 - Partition 5 account number
• Location 69 - Partition 6 account number
• Location 70 - Partition 7 account number
• Location 71 - Partition 8 account number
Locations 72 to 82 - Reserved
Locations 83 to 86 - Premise server name (Europe only)
Locations 83 to 86 have one segment of character data. Use these locations to
program the premise server name.
• Location 83 - Premise server name (characters 1 to 16)
• Location 84 - Premise server name (characters 17 to 32)
• Location 85 - Premise server name (characters 33 to 48)
• Location 86 - Premise server name (characters 49 to 64)
Location 87 - Automation (premise server) IP address
Location 87 has four segments of numerical data. Use this location to program
the automation IP address.