Interlogix NX-590NE - Manual (Page 27)

NX-590NE Internet Interface Installation Manual 25
Program worksheets
When the defaults in the worksheet tables have more than one segment, the
segments are shown separated by periods. For example, a default of
255.255.255.0, indicates there are four segments. To program the number, you
would enter 255 and press *, enter 255 and press *, enter 255 and press *, enter
0 and press * (press * between each segment entry).
Use Table 7 below to record your programming options for Location 0.
Table 7: Location 0 program worksheet
Loc Description Default Data
0 “Location 0 – Operation mode” on page 14
Segment 1
1. Use control dialer as backup to TCP/IP and e-mail
2. Backup format (Off = CID, On = SIA)
3. Use receiver 2 as backup
4. Send tag to onsite event recorder
5. Automation protocol enable (Europe only)
6. Premise server application using automation port (Europe
only)
7 and 8. Reserved
Segment 2
1. Enable site initiated downloading (*98 from keypad)
2. Enable remote initiated downloading
3. Use DHCP services (static IP of unit if Off). If enabled, we
recommend option 8 also be enabled.
4. Use DNS services (IP address used if Off)
5 to 7. Reserved
8. Polling enable
1, 2
Segment 3. Reserved
Segment 4
1. Enable SMTP e-mail authentication
Segment 5 to 7. Reserved
Segment 8. AUX COM Fail (for loss of polling only).
Use Table 8 on page 26 to record your programming options for Locations 1 to 4.