GTCO Cordless Roll-Up - Users Guide - Manual (Page 9)

Cordless Roll-Up 9
NOTE: The lithium battery used in this device may present a fire, explosion and severe
burn hazard if mistreated. Do not recharge, disassemble, heat above 212°F (100°C),
incinerate or expose to water.
1. Place the cursor button-side-down
on a table. Insert a small flat-
blade screwdriver between the
housing and the base in the area
shown in the figure. Gently pry
the housing off the base, taking
care that the screwdriver does not
slip and damage internal
components.
2. Carefully lift the base and place it
next to the housing as shown in
the figure. Please not the housing
and base are connected by two
coil wires. Keep the housing and
base close together to avoid
putting any strain on the wires.
3. Slide Connector “A” off Connector
“B”. Dispose of the battery
properly.
4. Attach Connector “A” of the new
battery to Connector “B”.
5. Place the battery in the well of
the base. Position the housing on
the base, taking extreme care that