GTCO Cordless Roll-Up - Users Guide - Manual (Page 51)

Cordless Roll-Up 51
2. Send the command one character at a time. The Controller will respond by echoing
each character. Waiting for the character to be echoed will ensure that the
Controller has received the character and is waiting for the next one.
3. Once the command is complete, send a or (hex 1B) to exit command
mode.
4. If you send a , go into a loop and grab one byte at a time until a > prompt is
received. Then continue sending commands as described in step 2.
Programming Example: To Send Version Command and Display Results
The QBASIC program interacts with the Cordless Roll-Up in Command Mode. In this
example, the program activates Command Mode, sends the VR command and displays the
resulting firmware version transmitted by the Cordless Roll-Up.
1. Configure Cordless Roll-Up for 9600, N, 8, 1, GTCO ASCII, Point (SuperSet 42).
2. Enter and run this QBASIC program: