GTCO Cordless Roll-Up - Users Guide - Manual (Page 20)

Cordless Roll-Up 20
3. Choose on the SuperSet Menu. This enters the first digit of the SuperSet code
for AutoCAD.
4. Select on the SuperSet Menu. This enters the second digit of the SuperSet
code for AutoCAD.
5. You will hear four short tones, indicating that the configuration is complete. The
Cordless Roll-Up is now configured to operate with AutoCAD. Select Mode is no
longer active.
NOTE: After beginning Select Mode, you must digitize only in the number blocks to
properly enter a SuperSet code. If you digitize in the tablet’s active area during Select
Mode, the sequence will be terminated and the previous configuration will be retained (you
will hear three medium-length tones after an aborted sequence). To cancel a sequence if
the first digit is entered incorrectly, digitize in the tablet’s active area.
Introduction to the Custom Configuration Menu
The Cordless Roll-Up uses the Custom Configuration Menu to control baud rate, data
format and other operating characteristics. The Custom Configuration Menu card is stored
in one end of the digitizer’s housing.
Configuration parameters for the Cordless Roll-Up are divided into three categories:
 Communication Options
 Output Format Options
 Mode Options
Using the Custom Configuration Menu
If the application does not have a SuperSet Menu code, or if a different configuration is
required, then use the Custom Configuration Menu card to configure the Cordless Roll-Up.
The Custom Configuration Menu replaces the 24 switches that were associated with older
GTCO CalComp by Turning Technologies digitizers.