GTCO Super L VI - Quick Start Guide - Manual

Contents
Verify that your Super L VI package includes the following:
 Super L VI digitizing tablet
 Transducer (corded or cordless pen,
4-button or 16-button cursor)
 USB cable
 CD-ROM with software drivers and
electronic user’s manual
 Registration card
 Table feet (non-bracket systems only)
Optional Equipment
 Plan hold down clamps
 Clear overlay
 QuikRuler III™ Measuring Module
 Universal mounting brackets
 Manual lift/manual tilt pedestal
 RS-232 kit (power supply and I/O
cable)
 Pen tray
NOTE: Some digitizing applications (typically, non-Windows CAD applications where the
tablet is used solely as a digitizer with no mouse functions) may not require the use of
TabletWorks software. To configure Super L VI for use with a third-party application, please
refer to the installation instructions in the Super L VI User’s Guide, where you will find a
complete list of vendor configuration settings.
NOTE: If your digitizing tablet came with a TabletWorks CD, install the software FIRST, and
then setup the hardware connections for USB (or the optional serial), following the
instructions below.
Software Configuration
Software drivers provide the communication bridge between your software application and
the Super L VI. GTCO CalComp by Turning Technologies-supplied TabletWorks CD supports
reduced functionality Wintab and TabCon-compatible applications. If you are not sure
about your application’s driver requirements, please contact your application vendor.