GTCO Cordless Roll-Up - Users Guide - Manual (Page 27)

Cordless Roll-Up 27
Resetting the Cordless Roll-Up
There are three ways to reset the Cordless Roll-Up:
 Enter SuperSet code 00
 Unplug and re-plug the power supply
 Send remote commands
When one of these events occurs, the Cordless Roll-Up will revert to the configuration that
was last defined. Any remote commands that were active before the reset will be lost.
Cordless Roll-Up Tones
The Cordless Roll-Up produces an “alarm” in the form of audio tones to inform the user of
various events. The table below describes the kinds of tones you may hear while operating
the digitizer.
Table 3: Cordless Roll-Up Tones
 Configuration error indicates that the Cordless Roll-Up may not be properly
configured for the application. If you hear this tone, reselect the appropriate
configuration from the SuperSet Menu.
 Diagnostics failed and Grid disconnected indicates serious problems. If you hear
either of these tones, contact GTCO CalComp by Turning Technologies Technical
Support Department at 1.866.746.3015.