GTCO Cordless Roll-Up - Users Guide User Manual
Page 8
Cordless Roll-Up 8
The stylus uses AAA batteries. Contact GTCO CalComp by Turning Technologies at
1.866.746.3015 for cursor batteries. (See Technical Specifications for battery type.)
Stylus Battery Replacement
The stylus uses an AAA battery.
1. Push in the clip on the
battery cover to remove it.
2. Pull the used battery from
its clip. Dispose of the
battery promptly.
3. Insert the new AAA battery
into the battery
compartment, positioning it
properly to ensure the
correct polarity.
4. Replace the battery cover.
Stylus Sleep Mode:
The stylus will enter sleep mode if there is no switch activity for approximately 20 seconds
or if any switch is held continuously active for approximately two minutes, to prolong
battery life.
Battery LED:
The LED will flash continuously when battery voltage has decayed to 0.9V nom. and the pen
is awake. The LED will flash four times when a battery is installed to indicate the pen is
ready to use.
Cursor Battery Replacement
Read the following instructions thoroughly before attempting to replace the battery in the
cursor. Failure to follow the instructions carefully could result in damage that would
render the cursor unusable.