GTCO Cordless Roll-Up - Users Guide - Manual (Page 21)

Cordless Roll-Up 21
Configurations set up can be stored in any of ten user-definable SuperSet locations (codes
90 through 99) for recall at a later time. This allows the Cordless Roll-Up to be easily
switched between applications.
To configure the Cordless Roll-Up using the Custom Configuration Menu:
1. Remove the Custom Configuration Menu card from its storage location in one end
of the housing. Place the card in the active area of the tablet (the entire menu must
be in the active area). Hold or temporarily tape the card in place to keep it from
moving during the configuration process.
2. Select on the SuperSet Menu. The alarm will beep slowly, indicating that the
Custom Configuration Menu mode is now ready to receive alignment Point 1.
3. Inform the Controller where the Custom Configuration Menu
card is located on the tablet. Choose alignment Point 1
(small blue square) in the lower left corner of the menu area.
The alarm will beep rapidly, indicating that the system is
waiting to receive alignment Point 2.
4. Pick alignment Point 2 (small blue square) in the lower right
corner of the card. After alignment Point 2 is selected, the
alarm will sound only of the transducer passes over an active
menu block on the card.
NOTE: If invalid alignment points are selected or if the menu card is not entirely in the
active area, the menu mode will be aborted. This is indicated by three medium tones from
the alarm.
5. Configure the Cordless Roll-Up by selecting the menu blocks that correspond to the
settings you want.
6. Review the configuration to ensure that the proper settings have been selected.
Pass the transducer down each group of options; the alarm will sound when the
transducer is over the active choice.